Description

The IS200JPDFG1A is a GE component made for the Mark VI system.The Mark VI was one of the last Speedtronic systems for gas/steam turbine management released by GE.This system was designed with Ethernet capabilities. The system's operator interface is designed using a PC running on a Windows platform. The IS200JPDFG1A is built with six toggle switches.These are located in a single line toward the center of the board.Three of these switches have a caution label attached above them that states: Caution: After removing power wait 30 sec before re-energizing.”The board has two vertical pin connectors (male) that are located on opposite short sides of the board. These are labeled P1 and P2. The board has eighteen fuses.Fuses are marked with their power ratings. The board has a total of fourteen plug connectors. This includes ten 2-position plugs, a 9-position plug, a 5-position plug, and two 12-position plugs. The IS200JPDFG1A is built with capacitors, diodes, and resistors.Resistors tend to be made of metal film material. The board has three box capacitors.Other capacitors are made of ceramic material. There are two TP test points located on the board; these are labeled NDC probe (HW2) and PDC probe (HW1.)There is a single transistor located near the P1 connector. The IS200JPDFG1A is a shaped board with two arms” that protrude from its back edge.The board has six conduction sensors located in its surface. Most components carry a reference designator.The GE logo appears on the board surface.