DS3800DBPF1A1A

GE FANUC STEAM TURBINE PC BOARD DS3800DBPF1A1A

Contact
Us!

Warranty: 3 Year Warranty
Manuals & Datasheets: Request via Email

DS3800DBPF1A1A

GE FANUC STEAM TURBINE PC BOARD DS3800DBPF1A1A

  • 4.50 (2)
  • Click a star to rate this product

Availability:

In Stock Ships Today


Description

The DS3800DBPF1A1A is a GE motor field board or printed circuit board (PCB) designed to be part of a Speedtronic Mark IV system. The Speedtronic Mark IV system was designed for the management of steam and gas turbine systems with significantly less downtime. GE achieved this by creating an interconnected system of microprocessing data boards with built-in redundancies; when one unit has an issue and needs to be serviced, the responsibilities of that board are automatically taken up by another chipset and the system continues to work as a whole, allowing for the repair of the damaged module with no lost efficiency. The DS3800DBPF1A1A is designed to be an ac input module.

The DS3800DBPF1A1A has the following attributes:

  • it has been factory-drilled at each corner of the board for one mounting option.

  • it has been created as an auxiliary board for GE Control Board model #6BA00

  • it has 5 connector pins to plug into the corresponding motherboard. These are located on the short sides of the DS3800DBPF1A1A, three on one side and two on the other, and are labeled 1,2,3 and 4 and 5.

  • it has one electromechanical communications relay (58614.) This sits parallel to one of the long sides of the board and is labeled HFW 1K 48 218A.

  • it has one CR capacitor

Please refer to the original manufacturer's data sheet or manual for procedures, precautions, and instructions relating to installation. Only qualified personnel should install the DS3800DBPF1A1A or other Mark IV components. Please follow all recommended safety guidelines.

Purchase

Please give us a call or send us an email for pricing on New Surplus and Reconditioned replacements that we have in our inventory. Our lead times are short, stock is excellent, and pricing is competitive. We hope to be your go-to supplier for all GE Turbine replacement boards and controls.

Exchange

We conveniently offer an exchange program that allows you to recycle your old board and receive an up-front discount on a replacement. Please ask about our exchange credit program if you have a defective board to exchange with the purchase of a new or reconditioned replacement. We ask that the defective board is sent in within 30 days of the purchase.

Repair

We offer repair on most GE Turbine boards we sell. Although we usually have replacements available, we recognize that customers may prefer to have their board repaired. Our repair program allows us to offer a lower cost alternative to replacement.