DS3800DADB1

DS3800DADB1 GENERAL ELECTRIC GAS TURBINE CONTROL PCB

Contact
Us!

Warranty: 3 Year Warranty
Manuals & Datasheets: Request via Email

DS3800DADB1

DS3800DADB1 GENERAL ELECTRIC GAS TURBINE CONTROL PCB

  • 4.00 (1)
  • Click a star to rate this product

Availability:

In Stock Ships Today


Description

The GE Gas Turbine Control Board DS3800DADB1 features one 20-pin ribbon cable permanently attached to the board and 3 pin-type connectors. The GE Gas Turbine Control Board DS3800DADB1 also is populated with terminals for attaching a variety of components. For example, depending on the processing needs, you can attach a resistor between 2 of the terminals. Other components are also sometimes attached between 2 terminals. For example, a capacitor might be connected between two terminals. A qualified installer or servicer only should attach components between the terminals. To insert a component, use a screwdriver to open the terminal and insert the lead wire into the terminal and use the screwdriver to tighten it. Then perform the same steps to secure the other lead wire to the appropriate terminal. Only a qualified individual will have the knowledge to understand what components are appropriate to achieve an expected result.

The IDs of the 3 pin-type connectors are P1, P2, and P3. The cables that attach to them are equipped with a matching pin-type component permanently attached to it. To attach the cable insert it into the connector on the board until it fits snuggly in the connector. To remove it, pull it straight out of the connector.

To perform any service or installation, the board must be removed from the drive and placed on a clean, dry, and level surface. To avoid static build up, wear a wrist strap and refrain from walking around carrying the board.

Purchase

Please give us a call or send us an email for pricing on New Surplus and Reconditioned replacements that we have in our inventory. Our lead times are short, stock is excellent, and pricing is competitive. We hope to be your go-to supplier for all GE Turbine replacement boards and controls.

Exchange

We conveniently offer an exchange program that allows you to recycle your old board and receive an up-front discount on a replacement. Please ask about our exchange credit program if you have a defective board to exchange with the purchase of a new or reconditioned replacement. We ask that the defective board is sent in within 30 days of the purchase.

Repair

We offer repair on most GE Turbine boards we sell. Although we usually have replacements available, we recognize that customers may prefer to have their board repaired. Our repair program allows us to offer a lower cost alternative to replacement.